Why practise these two together
Decimals and percentages are usually taught as separate topics, but they describe the same thing. A decimal is a fraction with a denominator of 10, 100 and so on, and a percent is a fraction out of 100. Moving between the two is only a matter of moving the decimal point two places: . The worksheets make this link useful. To find 25% of 80, a student changes 25% to 0.25 and then multiplies decimals, which is the skill the decimals worksheet trains.
This guide follows the fractions guide and uses the same settings-first approach. The topic pages for Decimals and Percentages already give a short path through the settings. This guide adds what they do not: the exact range of the numbers on each worksheet, a way to practise conversions between the forms, and a four-week plan.
From MathGem's creator. I recommend beginning with a small daily habit, one or two pages of about 10 to 30 problems, and increasing the amount gradually. After the four operations, the focus should move from the number of problems to understanding each new concept.
Before the worksheets
Two things need to be in place. The first is place value past the decimal point: in 6.47, the 4 is four tenths and the 7 is seven hundredths. The second is a feeling for fractions of one whole, so that , and are familiar amounts. Money is a good bridge for both. Dollars and cents are decimals with two places, and a quarter is exactly 0.25 of a dollar.
What the settings change
Decimals
- Addition and subtraction: the numbers are between 1 and 10 at either setting. The first number runs from 1.1 (or 1.01) to 9.9 (or 9.99) and the second from 1.0 to 9.0, with whole numbers left out so that a decimal point always shows. Subtraction puts the larger number first, so answers are never negative.
- Decimal places: the answer sheet and the problems drop trailing zeros, so a number such as 4.50 is printed as 4.5. At two decimal places, one problem can therefore mix tenths and hundredths, for example . That is useful practice: the student has to line up the decimal points, not the last digits.
- Multiplication: a decimal times a whole number from 2 to 9. The answer has as many decimal places as the decimal factor, apart from zeros that are dropped.
- Division: a decimal divided by a decimal, always with a whole-number answer from 2 to 9.
Percentages
- Percents: only ten values appear: 10, 15, 20, 25, 30, 40, 50, 60, 75 and 80. No other percent is used on any worksheet.
- Wholes: chosen from 20, 24, 25, 30, 36, 40, 48, 50, 60, 75, 80, 100, 120, 150 and 200, and only the combinations that give a whole-number part are used. That leaves 108 of the 150 possible pairs. The percent with the fewest options is 15%, which works with only seven wholes (20, 40, 60, 80, 100, 120 and 200).
- Question types: Find the Part, Find the Percent and Find the Whole all use the same pairs, so they are three views of one fact: .
Because the list is short, a student who works through several percentage pages will start to recognize the pairs. That is fine for building confidence, but it is a reason to ask for the working on a few problems rather than just the answer.
The ten percents in three forms
Learning these ten once, in all three forms, makes every percentage worksheet easier. They are worth writing on a card that stays next to the worksheet:
- 10% = 0.1 =
- 15% = 0.15 =
- 20% = 0.2 =
- 25% = 0.25 =
- 30% = 0.3 =
- 40% = 0.4 =
- 50% = 0.5 =
- 60% = 0.6 =
- 75% = 0.75 =
- 80% = 0.8 =
A four-week plan
Each week has four or five days of one page, and the last day is for review. If a week goes badly, repeat it instead of moving on.
- Week 1: adding and subtracting. Decimals, Addition and Subtraction at one decimal place on the first days, then two decimal places. Ask the student to estimate each answer first, because is a little more than 9. Watch for a decimal point that has slipped out of its column.
- Week 2: multiplying and dividing. Decimals, Multiplication, then Division. For multiplication, estimating with whole numbers shows where the point belongs: is about , and the exact answer is 19.2. Division can be checked by multiplying back: , because .
- Week 3: finding the part and the percent. Percentages, Find the Part first. Change the percent to a decimal, then multiply, and compare with the mental method: 15% of 80 is , and also 10% (8) plus half of that (4). Then Find the Percent, where the part goes over the whole: .
- Week 4: finding the whole, then a mixed review. Find the Whole is the hardest type, because the student divides by the percent: if 15 is 60% of a number, then . Check it by multiplying back: . End the week by alternating all three question types and one decimals page.
Using the answer sheet to practise conversions
The worksheets only ask for one form of the answer, but the answer sheet can start a conversation. After marking a Find the Percent page, pick three answers and ask for the same amount as a decimal and as a fraction: 75% is 0.75 and . Do the reverse after a Find the Part page: the answer 20 is of 80, so it is also 25% of 80. A few minutes of this does more for the link between the topics than an extra page of the same problem type.
When to move on
- Decimals are ready for percentages when addition and subtraction at two places come out right with the points lined up, and when estimates catch a misplaced point in a multiplication.
- Percentages are secure when the student can do 10%, 25% and 50% of a number without a pencil, and can say why the whole in a Find the Whole problem is larger than the part.
- Where mistakes cluster tells you what to repeat. A misplaced point sends the student back to place value, while a slip in dividing by a decimal usually means more division practice.
After percentages
Percent problems become ratios and proportions in Pre-Algebra, and later the same equation, part = percent × whole, is rearranged in algebra. The grade-by-grade practice roadmap shows how all of these fit together.